Test Equipment
- Analyzers »
- Impedance Analyzers
- Logic Analyzers
- Network Analyzers »
- DC - 3 GHz
- > 3 GHz - 8.5 GHz
- > 8.5 GHz - 26.5 GHz
- > 26.5 GHz - 50 GHz
- > 50 GHz
- Noise Figure Analyzers
- Parameter Analyzers
- Phase Analyzers
- Signal Analyzers
- Signal Source Analyzers
- Source Analyzers »
- Spectrum Analyzers »
- Generators »
- Meters »
- Oscilloscopes »
- Power Supply »
- Other »
ZV-Z55 - Rohde & Schwarz eCal Module
- Model: ZV-Z55
- Manufactured by: Rohde & Schwarz
Rohde & Schwarz ZV-Z55 (1164.0480.42) 10 MHz to 50 GHz, 2 Ports, 2.4 mm (f) Calibration Unit
Features:
+23 dBm Damage level
10 MHz to 50 GHz, 2 ports, 2.4 mm (f)
-45 dBm to +20 dBm Nominal Input Level Range
Automatic detection of connected ports
Extremely short warm-up time
Automatic detection, installation and control via USB interface
Used with R&S ZVA, ZVT or ZVB Series Analyzers
Reliable electronic switching
Description:
The Rohde & Schwarz ZV-Z55 is a Calibration Unit. Used with R&S ZVA, ZVT or ZVB Series Analyzers. Rohde & Schwarz offers a number of automatic calibration units for high-speed and error-free system error correction of its network analyzers.
The analyzer detects the ZV-Z55 calibration unit automatically after the USB cable is connected. At room temperature, the calibration units are immediately ready for operation.
Recharacterization of the ZV-Z55 calibration unit by the user (e.g. to enable any combination of connector types on the analyzer and the calibration unit by using adapters and treating them as part of the calibration unit; requires a manual calibration kit for each connector type used on the calibration unit)
Features:
+23 dBm Damage level
10 MHz to 50 GHz, 2 ports, 2.4 mm (f)
-45 dBm to +20 dBm Nominal Input Level Range
Automatic detection of connected ports
Extremely short warm-up time
Automatic detection, installation and control via USB interface
Used with R&S ZVA, ZVT or ZVB Series Analyzers
Reliable electronic switching
Description:
The Rohde & Schwarz ZV-Z55 is a Calibration Unit. Used with R&S ZVA, ZVT or ZVB Series Analyzers. Rohde & Schwarz offers a number of automatic calibration units for high-speed and error-free system error correction of its network analyzers.
The analyzer detects the ZV-Z55 calibration unit automatically after the USB cable is connected. At room temperature, the calibration units are immediately ready for operation.
Recharacterization of the ZV-Z55 calibration unit by the user (e.g. to enable any combination of connector types on the analyzer and the calibration unit by using adapters and treating them as part of the calibration unit; requires a manual calibration kit for each connector type used on the calibration unit)
Your IP Address is: 18.119.132.24
Copyright © 2024 RFTE Solutions