Test Equipment
- Analyzers »
- Impedance Analyzers
- Logic Analyzers
- Network Analyzers »
- DC - 3 GHz
- > 3 GHz - 8.5 GHz
- > 8.5 GHz - 26.5 GHz
- > 26.5 GHz - 50 GHz
- > 50 GHz
- Noise Figure Analyzers
- Parameter Analyzers
- Phase Analyzers
- Signal Analyzers
- Signal Source Analyzers
- Source Analyzers »
- Spectrum Analyzers »
- Generators »
- Meters »
- Oscilloscopes »
- Power Supply »
- Other »
N4692A-00F - Keysight (Agilent) Electronic Calibration Module
- Model: N4692A-00F
- Manufactured by: Keysight / Agilent Technologies
Keysight Agilent N4692A-00F N4692-60003 Electronic Calibration Module (ECal), 10 MHz to 40 GHz, 2.92 mm, 2-port
Option Installed:
00F - 2.92 mm (F) Connector on both ports
Features:
10 MHz to 40 GHz frequency range
USB interface for direct control with PNA and ENA series of network analyzers
Alternative 85097B interface when used with other analyzers
Fast calibration
Full two-port calibration with a single connection
Reduced connector wear
NIST traceable accurate calibrations
Reliable solid-state switching
Description:
The Agilent N4692A MW electronic calibration (ECal) module makes calibration of vector network analyzers fast, easy and accurate. The RF ECal system is now easily controlled by one of two methods depending on the network analyzer. The Agilent PNA and ENA series of network analyzers controls the module directly via the USB interface. The modules can also be controlled via an 85097B interface kit when used with an Agilent 8753E/ES/ET or 8720D/ES/ET. (This requires a special parallel cable and firmware Rev. 7.74).
ECal is an ideal solution for calibrating network analyzers. Performing a full two-port calibration takes less than half the time and number of connections using ECal versus mechanical cal kits. Furthermore, the accuracy of the calibration is comparable between electronic and mechanical methods. Traditional mechanical calibrations require intensive operator interaction which is prone to errors. With ECal, the operator simply connects the ECal module to the network analyzer and the software controls the rest.
Option Installed:
00F - 2.92 mm (F) Connector on both ports
Features:
10 MHz to 40 GHz frequency range
USB interface for direct control with PNA and ENA series of network analyzers
Alternative 85097B interface when used with other analyzers
Fast calibration
Full two-port calibration with a single connection
Reduced connector wear
NIST traceable accurate calibrations
Reliable solid-state switching
Description:
The Agilent N4692A MW electronic calibration (ECal) module makes calibration of vector network analyzers fast, easy and accurate. The RF ECal system is now easily controlled by one of two methods depending on the network analyzer. The Agilent PNA and ENA series of network analyzers controls the module directly via the USB interface. The modules can also be controlled via an 85097B interface kit when used with an Agilent 8753E/ES/ET or 8720D/ES/ET. (This requires a special parallel cable and firmware Rev. 7.74).
ECal is an ideal solution for calibrating network analyzers. Performing a full two-port calibration takes less than half the time and number of connections using ECal versus mechanical cal kits. Furthermore, the accuracy of the calibration is comparable between electronic and mechanical methods. Traditional mechanical calibrations require intensive operator interaction which is prone to errors. With ECal, the operator simply connects the ECal module to the network analyzer and the software controls the rest.
Your IP Address is: 3.15.192.157
Copyright © 2024 RFTE Solutions