Test Equipment
- Analyzers »
- Impedance Analyzers
- Logic Analyzers
- Network Analyzers »
- DC - 3 GHz
- > 3 GHz - 8.5 GHz
- > 8.5 GHz - 26.5 GHz
- > 26.5 GHz - 50 GHz
- > 50 GHz
- Noise Figure Analyzers
- Parameter Analyzers
- Phase Analyzers
- Signal Analyzers
- Signal Source Analyzers
- Source Analyzers »
- Spectrum Analyzers »
- Generators »
- Meters »
- Oscilloscopes »
- Power Supply »
- Other »
ZV-Z54 - Rohde & Schwarz Calibration Unit
- Model: ZV-Z54
- Manufactured by: Rohde & Schwarz
Rohde & Schwarz ZV-Z54 Automatic Calibration Unit, 2.92 mm (f), 2 Ports, 9 kHz to 40 GHz
Features:
Wide frequency range 9 kHz to 40 GHz
2 ports, 2.92 mm
Virtually no warm up time required
Auto-detection and USB control
Multiport calibration supported
Description:
The Rohde & Schwarz ZV-Z54 is a Calibration Unit. Used with R&S ZVA, ZVT or ZVB Series Analyzers. Rohde & Schwarz offers a number of automatic calibration units for high-speed and error-free system error correction of its network analyzers.
The analyzer detects the ZV-Z54 calibration unit automatically after the USB cable is connected. At room temperature, the calibration units are immediately ready for operation.
Recharacterization of the ZV-Z54 calibration unit by the user (e.g. to enable any combination of connector types on the analyzer and the calibration unit by using adapters and treating them as part of the calibration unit; requires a manual calibration kit for each connector type used on the calibration unit)
Features:
Wide frequency range 9 kHz to 40 GHz
2 ports, 2.92 mm
Virtually no warm up time required
Auto-detection and USB control
Multiport calibration supported
Description:
The Rohde & Schwarz ZV-Z54 is a Calibration Unit. Used with R&S ZVA, ZVT or ZVB Series Analyzers. Rohde & Schwarz offers a number of automatic calibration units for high-speed and error-free system error correction of its network analyzers.
The analyzer detects the ZV-Z54 calibration unit automatically after the USB cable is connected. At room temperature, the calibration units are immediately ready for operation.
Recharacterization of the ZV-Z54 calibration unit by the user (e.g. to enable any combination of connector types on the analyzer and the calibration unit by using adapters and treating them as part of the calibration unit; requires a manual calibration kit for each connector type used on the calibration unit)
Your IP Address is: 13.58.220.206
Copyright © 2024 RFTE Solutions